This easy puzzle box can be opened by twisting the container into a heart and then splitting it into two separate hearts.
Customization
The box frame contains extra magnet holes to support alternate configurations. Do not add magnets to every hole.
The box can be assembled to unlock either in the heart configuration or in the rectangular configuration.
All parts are labeled "left" or "right" with an unlocked heart configuration in mind.
If you want the box to start out as a locked heart and separate in the rectangular configuration, print "Alternate_Key.stl"
Rather than printing one right lid and one left lid, you may choose instead to print two lids from the same side, which will alter whether the boxes open from the front and back. If you do this, make sure you also print the correct bottom parts to match.
Printing
All parts of this design can be printed with zero supports.
However, the key hole in "Frame Right.stl" must print very cleanly. To reduce the amount of bridging involved, an alternate "Frame Right with Custom Supports.stl" file is available. This adds a small printed plug in the key hole that can be removed relatively easily after printing.
If your printer experienced curling, add a brim to all parts that have sharp corners.
Assembly
Required Hardware
Three M3 bolts that are 8-12mm long. For best results, use 10mm long bolts.
Recommended Hardware
Eight 3x3mm cylinder magnets to align the lid.
Four 6x3mm cylinder magnets to pull the frames together. Additional holes in the side of the frame are available to support 3x3mm cylinder magnets.
Steps
Attach the key to the left frame and secure with an M3 bolt. Glue is optional. Glue magnets as desired. Make sure magnets are oriented to align the lids and pull the frame together both in the heart and rectangle configuration. Use M3 bolts to attach both lids to their frames. Do not over-tighten, or the lids will break or be too tight to rotate. Glue on bottoms to each frame.
Can I sell copies of this?
Yes! This project was shared under the Creative Commons - Attribution license.
This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.
Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.
This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.