VR battery holder [!UPDATED!]

Have vive pro and the battery connector slowly died out on me so after  eventually getting another battery (VRULC t2055) that was 20,000mah (bit bigger than the original) i Was set out on a journey to somewhat recreate the vive battery waist holder thingy so this is basically that but for a bigger battery. use 2x 2.5m screws and nuts to hold plastic retainters in to hold the battery in. pause the print at layer 596 (easiest to do in slicer software) [test it at the 2nd layer hieght just in case]   AFTER YOU HAVE CORRECTLY PAUSED IT... insert hex nuts in the holes at the side. i used a soldering iron at its lowest setting (210C) to snugly ensure the went in smooth and straight and tight. unpause printer and allow it to print over top. add the bolts later. the back clip is somewhat fragile (hasnt broke yet after a few drops [PLA] )and make sure it is properly supported when printing. if not it will move forward and back and its not gud at all.

:)

VIVE WIRELESS

Most Popular of All Time

Categories

Popular

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

VR battery holder [!UPDATED!]