3D Printable Maze Puzzle Box - STL File.stl
8.1K downloads · 5 years ago · This is an updated version of my original Maze Puzzle box. This one works better and makes it imposs
This is an updated version of my original Maze Puzzle box. This one works better and makes it impossible to cheat when close to the end of the maze.
This is an STL file with the parts set side-by-side, ready to 3D print!
3D Printable Maze Puzzle Box - STL File.stl
8.1K downloads · 5 years ago in and
3D_Maze_Puzzle_Box
Anti-Cheat 3D Maze Puzzle Box
3D Maze Puzzle Box - Print-ready STL "Anti-Cheat" version
3D Maze Box (Costumizable puzzle!)
Bundle
Yin Yang Annoying Box – 84-Screw Puzzle Gift Box
Gear Pathing Maze Puzzle nr. 4
Gear Pathing maze Puzzle 1
Gear Pathing Maze Puzzle nr. 5
Gear Pathing Maze Puzzle nr 2
Gear Pathing Maze Puzzle nr. 3
Book Nooks & Puzzle Boxes Collection - 10-Model STL Bundle for 3D Printing
Melting Cube #Gift Box and Puzzle Box
PuzzleLock Box — Lock and Puzzle in a Box
Slider Maze Level 2 - ultimate sliding puzzle
Display Stand for puzzle: Flower Maze by Constantin Puzzles
Egg Jail: Festive Easter egg lock box with a Maze Challenge
Slider Maze puzzle nr 6.
Puzzle Box
Advanced Puzzle Box
I love this model and it works great. But the correct path is a bit to easy, it works great for my 10 year old, but I would like one that basically takes you all around the maze, going up and down a lot. Are you planning on a harder version or has anyone remixed it to be harder?
Try this one. It does what you are asking. https://www.printables.com/model/133742-labyrinth-puzzle-gift-box
Worked great thanks
Great model! Only problem is that whenever you fully close the box, the top is kind of loose and slides from side to side and if you pull on it hard, you can cheat and the box will break
I would like to remix the maze could I get an ungrouped file.
Could we get this as two separate files, I'd like to print them in different colors. Thanks
you can just pause the print when one is done then change filament and countinue
Super!!
thanks this worked great
thx for converting
Thangs Marek and Jim. I've uploaded the new version (replaced original) with the fixed notch location.
Do you need any support when printing this with Ender 3 pro using PLA? In cura it shows me some red marks on the overhangs, meaning that the file should be fixed(thats what it tells me), and ive tried some other models, and it fails at the overhangs, should i use something else than cura? thanks
As jimjobe says, it can not be closed in position matching 2 arrows.