Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5512396.

Model has been moved to Printables.com:

• https://www.printables.com/model/116958

This is a label holder designed for IKEA IVAR system or any plank shelf with thickness above 1.6cm.

The model has guides included so it is always perfectly leveled and centered on a 1.8cm planck (IVAR IKEA & other).

It gives a nice 2mm gap below the planck so it does not block object from the top of the planck (see video and photo).

Screw hole is centered with model so label holder can easily be centered on the plank (one measurement operation)

Label holder has chamfer on top so label is easier to insert.

• label holder (3D part): I usually print it @ "0.2mm quality" because of the low wall thickness. No support, no brim
• Label (paper): Cut in a thick paper 16mm x 79mm with maximum thickness of 2mm. I cut mines on a laser cutter for nicer results and rounded corners
• Screw: made for a 2.5mm diameter screws. 8mm length is more than enough.