Are you worthy of carrying your most powerful decks? Meet the Mjolnir Commander Deck Case! This epic premium storage box is shaped exactly like the mythical hammer of thunder, designed specifically for Commander (EDH) and standard TCG players who want to make a legendary entrance at their local game store.

The interior is highly spacious, comfortably fitting 100 double-sleeved cards plus tokens. Alternatively, it can hold up to two 60-card sleeved decks. The design requires minimal support material during printing and features a robust screw-on connection for the handle.

✨ Key Features:

TCG Optimized Capacity: Fits 100+ double-sleeved cards + tokens, or two standard 60-card sleeved decks.

Magnetic Closure System: Features precise slots for 6 magnets (10x1 mm) to keep the main shell securely shut during transport.

Heavy-Duty Threaded Handle: The connection between the handle and the hammer uses a custom-engineered tight screw thread. It is deliberately snug so that once it is fully assembled, it stays rock-solid without needing any glue.

2-Color Handle Printing: Designed to be printed easily in two colors using simple pauses and filament swaps. The included 3MF file has these pauses pre-programmed for your convenience!

Fuzzy Skin Texture: The handle looks spectacular with a "Fuzzy Skin" finish applied via Bambu Studio (as seen in Mjolnir Commander Deck Case 1.jpg). However, you can toggle it off if you prefer a perfectly smooth, sleek aesthetic.

Authentic Pommel Hole: Includes an opening at the bottom of the pommel to attach a leather strap or cord, fully replicating the classic look of the legendary hammer.

⚠️ Important Usage Note: While the magnetic closure is strong enough to securely hold your deck during normal transport and handling, this is a deck box, not a cosplay prop! If you start swinging it around like Thor in the middle of the room, the kinetic force will eventually pop it open. Keep it safe, carry it normally, and your cards will remain perfectly protected. (If you lose your match, that’s on you—not the hammer!).

All Markus3D designs are Copyrighted and for PERSONAL USE ONLY. To sell prints of my models, you can subscribe to my Patreon or Thangs with the commercial tier membership. Digital files can’t be shared or resold!

➡️Patreon Markus3d

➡️Thangs Markus3D

➡️You are welcome to follow my socials, check all my links or contact me here!

🔧 Recommended 3D Printing Settings:

🖨️ Layer height: 0.2 mm 🖖 Walls / Perimeters: 3 🔄 Infill: 15% - 20% 🚫 Supports: Minimal supports required for specific overhangs. 🪢 Texture: Enable "Fuzzy Skin" on the handle section in your slicer for a realistic grip effect.