Hold onto your butts! This shadow box features the famous T-Rex escape scene from the original Jurassic Park movie. Each layer is 3D printed in a separate color and then stacked on top of each other to create the illusion of depth. Add the toy vehicle to make it more like a diorama. The exterior features screw holes in the back and top if you want to hang it on a wall. It also looks great just sitting on a desk or shelf.

Assembly Instructions Print each part using the color recommendations provided. Print out 6 of the square spacers. PLA filament was used but other materials may work as well. You will need white paper, scissors, and glue.

1.) Lay box shell on flat surface with opening face up. Make sure screw holes are positioned upright.

2.) Cut out small piece of white paper to fit into shell. Glue into place. This white layer will serve as the moon.

3.) Place blue sky layer inside shell on top of the white paper. Glue into place. Wait for glue to dry.

4.) Add spacers to corners. Glue into place. Wait for glue to dry.

5.) Add square spacer layer. Glue into place. Wait for glue to dry.

6.) Repeat steps with the remaining layers in this order: Clouds, Mountains, Plants Back, Dino, Plants Front, Fence. Be sure to place the 4 corner spacers and the square spacer between each layer. Glue everything in place. Wait for glue to dry between each layer.

7.) Add the lid with glue to seal it shut. Wait for everything to dry.

8.) Stand the box up and place the car ramp in front of it with your choice of vehicle (not included).

You can also make the secondary version of this diorama by not using any of the spacers. That way there is more room inside the box to fit both the ramp and the vehicle!