This is a Material Clamp Kit accessory for the Lil' Lupo Rotary Tool Drill Press:

https://thangs.com/designer/LeatherLupo/3d-model/Lil%27%20Lupo%20Rotary%20Tool%20Drill%20Press%20w%20Modular%20Accessories-1514786

Nothing's better than an extra set of hands when you're working. The spring-loaded clamp arms hold material firmly into place. Very convenient when doing delicate or precise work.

**Your offset needs to be dialed in properly - if you have too much squish (layer compression) the pieces will not snap together correctly. **

This clamp kit is a snap-fit assembly that clicks onto the Sanding Rig Base Plates or the Drill Plates. **I used 10mm OD medium-stiff springs. You can repurpose old springs or buy new ones, but you don't want very stiff or thick springs. I used 4x 40mm hex bolts. The length of the bolts will be determined by the springs you use.

Best printed with PLA+ at 10% moisture with 50% triangular infill.

Dry your filament, eat your vegetables, don't do drugs.