This is a frame to mount the Inky Impression - 13.3” from Pimoroni (2025 version). The frame is sliced in two halves to fit on the print plate. There are two "combiners" that connect the two halves, one has a hole to be used as a hook. You need 4 of the "clamps" to properly hold the board. All 12 screws are M4x15 and need the respective heat set inserts. Designed in FreeCAD, files are attached. The buttons on my version of the Inky Impression are in the back (pressed FROM the back), therefore I have large gaps on that side that allow to access them with fingers. I forgot to leave a hole for the LED.