ALL Flexi Factory designs are protected by Copyright Law. When you purchase, you do NOT have the right to sell any digital file or printed model of my designs without my explicit written consent.

To legally sell PRINTED models, monthly ACTIVE membership is required through one of two available platforms below:

https://linktr.ee/flexifactory

Please help support the creative work of each 3D artist and NEVER share or sell a digital file. ....................................................

Thank you to all of you who suggested the Parasaurolophus! It took me a bit of time to noodle the beautiful crest, which is such an important part of its character. My wife keeps on calling her Diva... names after Diva Plavalaguna from Fifth Element 🤣

As usual, I created two head versions (with and without the eye), a stand, and since this Dino is an herbivore, A little prehistoric broccoli. I have also added an XXL/Cut Version that needs to be glue together.

Included in two Zip Files: Extract each fully for all parts.

• Stand, Accessories, snap on head with eyes and without eyes
• XXL Version is cut and must be super glued together. Scale all parts equally before printing.

Like with all my Flexi's, I went through many iterations to make sure it was strong, and easy to print without supports.

Please feel free to share images of your prints on this page, I would love to see 'em.

Thank you.

P.S. If you like this design, Check out my other models.

https://www.cults3d.com/en/users/FlexiFactory/creations

Affiliate link to my supplies used in the photos above can be found here: https://www.amazon.com/shop/flexifactory

*As an Amazon Associate I earn from qualifying purchases.

3D printing settings STL and 3MF files are included. * If you use the 3mf file, please remember that it is a painted project file for your convenience. You must check your material/printer/settings to make sure it works correctly for your printing project.

I print with .12 or .16 layer height for quality.

As usual, make sure you have good adhesion, especially for the mini versions. A glue stick works or I have switched to using on all my machines... a BIQU Cryopgrip Frostbite adhesion plate.

I successfully test printed between 50% and 310% XXL for this design.

XXL version must be GLUED together with Super Glue. I still suggest no supports, though you may have some "roughness" due to bridging on the underside of the rib bones.

Gradient PLA works well with this model: I have a comprehensive list of Filament I use here: Amazon List: https://amzn.to/4oOrYhx