PERSONAL USE ONLY For Commercial Licence please join the Tier of your choice on our Patreon.

https://www.patreon.com/c/AdAstra3DPrints

About the Model: Multipart print for Bromjunaar Sanctuary. Featuring all Dragon Priests and Konahrik in the middle.

This print has been tested with FDM printers at 20 cm length.

The Center Skull is hinged so it can open and close.

Supports needed only for the skull since it must be printed on supports so the hinges can succeed. If you dont care about the hinges and you just want to use it as a cap then i suggest printing it as is, cut the hinges and sand that part before painting.

If you decide to print very small then i cant guarantee that the hinges will come out well enough unless you print with Resin.

3D PRINTING SETTINGS

FDM Printers 3 walls 10-15% infill Supports needed only for the top Dragon skull part 0.20 Layer Height

AMS / CFS is partly supported. This model must be manually painted in the slicer. Found it easier just to hand paint it and varnish it.