• Featuring Simple Penguin, Penguin with a scarf, Crested Penguin, Emperor Penguin ✔
• Contains 4 Base and Cap designs ✔
• Support-free ✔
• Keychain version included ✔
• Printable with AND without AMS ✔

📋 Print Settings Recommendations (for Caps)

• Layer height: 0.2mm
• Line width Default (Quality): 0.33
• Wall generator (Quality): Arachne
• Initial Layer Flow Ratio (Quality): 1.03 (in Develop Mode)

(You may adjust this setting as needed depending on your printer’s calibration!)

• Only one wall on first layer (Quality): ON
• Bottom Surface Pattern (Strength): Concentric
• Slow down for overhangs (Speed): OFF

📋 Print Settings Recommendations (for Bases)

• .20mm Standard @BBL

🎨 Filament Used

• 🤍 Cotton White (Polyterra PLA)
• 🩶 Ash Grey (Polyterra PLA)
• 🖤 Charcoal Black (Polyterra PLA)
• 🧡 Sunrise Orange (Polyterra PLA)

🛠️ Hardware Used

• 🖨️ Bambu Lab A1 Mini Combo (with the AMS Lite) and a .4mm nozzle
• ⌨️ Glorious Kailh Switches (Box White)

If you've got any suggestions, feel free to reach us out!