I wanted a hinged lid for the Multibins in my tool box at work to keep unwanted stuff from falling into them. This is what i came up with. Using these to remix, https://makerworld.com/en/models/1095371-hinge-mini#profileId-1089679, https://makerworld.com/en/models/1420491-1x1-multibin-snap-lid#profileId-1475748 I was able to make something. You can use the holding pins or the drawer stoper pin, but they are kind of loose so, I combined them into “Improved Outer Corner Holding Pins”. One type has a loop to grab so they can be removed the other doesn't. Be mindful they are VERY tight and don't come out on their own. Also there are three different lids with tabs to facilitate opening, left tab, right tab, and dual tabs.