Miyabiboo Ear Chopsticks MULTICOLOR PRINTING REQUIRED DISCLAIMER: Using 3D printed Chopsticks right off the plate is NOT recommended due to food safety concerns! Please make sure you are treating the print into being food safe before using on actual food. And do not wash them in the dishwasher!

If you are using these just for display, then don't worry about the disclaimer :)

This model may go through improvements and updates! Please let me know through IG or Tiktok (@Pneuma3D) if you have any feedback to share!

This model set comes with two main pieces that are split into even smaller parts:

• The Miyabi Ear (ME) Chopsticks
• The Miyabi Ear (ME) Chopstick Stand

The names of each stl will be described below so make sure you read everything before printing! Adhesives like super glue may be necessary to keep together

ME Chopsticks These are the files you will need to print the chopsticks themselves (each stl is only one chopstick so obviously you will need to print two for the complete pair):

• ME_Full_Chopstick_With_Fluff.stl Full Model
• ME_Full_Chopstick_No_Fluff.stl Full Model without fluff piece
• ME_Split_Chopstick_Fluff_Piece.stl Fluff piece inserted in chopsticks

These splits are the ones I used for the video but honestly could use some improvements:

• ME_Split_Chopstick_1.stl
• ME_Split_Chopstick_2.stl
• ME_Split_Chopstick_Connector.stl pieces above have an insert slot for this piece, place it inside for alignment

Here are some chopstick splits I was experimenting with if you want to try them out yourself:

• ME_Test_Split_1.stl
• ME_Test_Split_2.stl

ME Stand These are files you will need to print the chopstick stand/holder

• ME_Full_Stand.stl Full Model
• ME_Split_Stand_Head.stl
• ME_Split_Stand_Face.stl
• ME_Split_Stand_Arms.stl
• ME_Split_Stand_Legs.stl
• ME_Split_Stand_Legs_with_Platform.stl recommended, these legs stand on a platform so the stand does not fall easily
• ME_Split_Stand_Connector.stl

3mf Files These are the 3mf files that include all the parts listed above but colored and best used for multicolor printing:

• ME_Chopsticks_3mf.3mf
• ME_Stand_3mf.3mf

This work by Pneuma3D is licensed under CC BY-NC-SA 4.0