Last art piece this evening:

For this model: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x200mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used: PLA Bambu Labs Basic Black (10101) Transmission Distance: 0.6 PLA Bambu Labs Basic Jade White (10100) Transmission Distance: 5 PLA Bambu Labs Basic Maroon Red (10205) Transmission Distance: 3 This print uses 3 unique filaments

Swap Instructions: Start with Black (10101) At layer #11 (0.96mm) swap to Jade White (10100)

Border Only Colors from here until the end. At layer #18 (1.52mm) swap to Maroon Red (10205)

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #32 (2.64mm) swap to Jade White (10100) for the rest.