Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 142.93x200mm in size

Filaments Used: PLA Elegoo Black PLA Elegoo Navy Blue Matte PLA Elegoo Orange PLA Elegoo Yellow PLA Elegoo White This print uses 5 unique filaments

Swap Instructions:

Start with Black At layer #17 (1.44mm) swap to Navy Blue Matte At layer #21 (1.76mm) swap to Orange At layer #25 (2.08mm) swap to Yellow At layer #30 (2.48mm) swap to White for the rest.

You can start with navy blue instead of black if you'd like. I designed it with the black because I have plenty of black filament but only one roll of navy blue. None of the black is actually visible from the front.

This is the first hueforge model I've created, so feedback is always welcome.