The Antlerdragon was released a couple of years ago, and it’s a design I’ve always been fond of.

It only struck me recently that I had never created a medium version only large and small.

So, I set out on a little quest: Updating the joints to make them sturdier, adapting the design for 8mm glass eyes, and finally bringing a medium sized Antlerdragon to life. I hope you’ll enjoy this new version just as much as the original.

Important when downloading/buying the design:

This design (as all Sassiecat3D designs) is under copyright. Which means, upon purchase, you do NOT have the right to sell commercially.

The Digital files are never to be re-sold, shared, or given away!

If you would like to legally sell the printed files commercially, please join our Tribe, Thangs or our Patreon and subscribe to the Commercial Tier.

https://www.patreon.com/c/Sassiecat3d

https://thangs.com/designer/sassiecat3d

https://www.myminifactory.com/users/Sassiecat3d#/

3D PRINTING SETTINGS: I used a .4mm nozzle, .2mm layer height, I use 5% infill. Make sure your printer is all set with a good calibration and retraction before printing it.