A bunch of you asked for a version without the clicker mechanism, so here it is! This retro food container still brings all the charm, just without the click. Use it as a keychain or magnet. Inspired by grandma’s pantry, it’s a fun little dose of nostalgia for your desk, bag, or as a gift!

This design works with both AMS and non-AMS printers and easy to assemble!

Print Settings If you'd like to see the orientation and settings of the print, please take a look at the .3mf file.

Lid (Transparent PLA):

• No brim
• No supports needed
• 100% infill
• 2-3 walls
• 0.4mm nozzle
• 0.28mm layer height

All other components:

• No brim
• Supports needed for the magnet base.
• 15% infill
• 2-3 walls
• 0.4mm nozzle
• 0.2mm layer height

Magnet Assembly Instructions:

• Place the magnet inside the bottom of the food container.
• Apply glue around the magnet bottom ring.
• Press the magnet bottom ring into place, aligning it with the base of the food container.
• Hold or gently press for a few seconds, then let it dry completely before using.

Items Used:

• Tan: https://www.matterhackers.com/store/l/pro-series-pla/sk/MZE7T0ST?aff=7646
• Sage Green: https://www.hatchbox3d.com/products/hb-pla-1kg1-75-sgrn
• Transparent Clear: https://amzn.to/3ZtnoL5
• Neodymium Disc Magnet, 1.26 inch x ⅛ inch: https://amzn.to/3Q9cdT1

Important Note: Not suitable for young children. Contains small parts that may pose a choking hazard.