Low profile housing for the Gaggiuino ToFnLED. Compatible with the PCA9632 version (tested), and NCP5623 version (based on the KiCAD files).

This print can be sensitive to printer tolerances. Ensure that your print does not have elephant feet, and that the ToF sensor holes are not covered in plastic.

You will require (8) 5x2mm magnets and some kapton tape.

1. Press fit the magnets into the 4 holes.
2. Tape the exposed solder pads on the rear of the PCB.
3. Remove the protective film over the ToF sensor (if not already done).

To use the SCAD file, you will need OpenSCAD and the BOSL2 library.