Batter up…again and again with this bat and ball impossible pass through fidget I designed two styles of bats: one with a keychain hole and one without.

Update 5/12/25: I added a few new models. I wanted more spin with the ball so made a tighter 'twist' pattern on the bat (initially it rotated 450 degrees now it rotates 600 degrees). These files are titled Small Bat v2 (no hole), Small Bat v2 (with hole) and Small Ball v2. I also added a Big Bat and Ball just because 😊

3D PRINTING SETTINGS: Layer Height 0.2mm PLA works great 15% Infill Supports needed for baseball Brim added to bats

Dimensions of Small Bat & Ball assembled: 4 in. x 1 in. Dimensions of Big Bat & Ball assembled: 8.5 in. x 2 in.

How to Print:

• Print the baseball first (Tip: change the “top Z distance” in support tab to 0.275mm to make the supports easier to remove)
• After the baseball it printed, print the bat pausing the print at layer 374 (for the small bat) and layer 764 (for the big bat) to place the ball on the bat (let it twist down) and then resume the print.

That's it!

Have fun printing:) Erin