This Minecraft Helmet is printed with following order of filament colors :

1. CC3D Silk PLA Black
2. Overture PLA Space Gray
3. Elegoo PLA Gray
4. GiantArm PLA Matte Light Gray
5. Elegoo PLA White

Each armor pieces requires TWO 12x3 magnets. The following print settings are a must:

• 0.2mm layer height (necessary for the pauses)
• 2 shells/perimeters (can be increased if you want to use more filament)
• 4 top surfaces
• 15% infill
• slow down top layer to around 60-80mm/s
• 15mm Mickey Mouse Ear brim attached at 0mm if you're uncertain about your bed adhesion at the corners
• Colors & Pauses: Start printing with CC3D Silk Black Layer 19 (3.8mm) - Insert magnets with a drop of glue to prevent sticking to nozzle Layer 57 (11.4mm) - switch to Overture Space Gray Layer 61 (12.2mm) - switch to Elegoo Gray Layer 65 (13mm) - switch to GiantArm Light Gray Layer 69 (13.8mm) - switch to Elegoo White