A mechanical storage box with the theme of the videogame Helldivers 2. Perfect for storing screws, super-credits or your favourite candy. This model is also a great gift for Helldivers players.

No extra parts are needed - the model is fully Print-In-Place! You only need to drive a knife down between each triangle to remove the 2 thin overhang supports (Check picture for reference)

Painted 3mf-files for multicolour printing (4 colour) is included and also STL-files. Model in the pictures uses yellow, black, grey and white. If you print with those four colours at 100% scale, the model will use approximately 225g black, 36g yellow, 24g grey and 47g white of filament.

I recommend printing in PLA, but if you decide to print in silk PLA, then you have to apply lubricant into the six gears and inside the rotatable ring.

The model is approximately 11cm high and 10cm wide, and has an inside diameter of 6cm

If you're having trouble with the ring and base fusing together, then you can use a knife to separate them, or scale the model up. If the rotatable ring doesn't rotate smoothly, then apply lubricant - but out of all of the test I made, it always rotated smoothly with PLA.

Do not print the model with supports I recommend you to not scale the model down 0.2mm layer height or lower 15% infill