This Minecraft Sword is printed with following order of filament colors :

1. Sunlu PLA Brown
2. Elegoo PLA Brown
3. Ziro PLA Sparkly Green
4. Elegoo PLA Sparkle Turquoise
5. Sunlu High Speed PLA Mint Green
6. Sunlu High Speed PLA Ice Blue

Each tool requires TWO 12x3 magnets. The following print settings are a must:

• 0.2mm layer height (necessary for the pauses)
• 2 shells/perimeters (can be increased if you want to use more filament)
• 4 top surfaces
• 15% infill

OPTIONAL SETTINGS:

• slow down top layer to around 60-80mm/s

• ironing

• 15mm Mickey Mouse Ear brim attached at 0mm if you're uncertain about your bed adhesion at the corners

• Colors & Pauses: Start printing with Sunlu Brown Layer 19 (3.8mm) - Insert magnets with a drop of glue to prevent sticking to nozzle Layer 59 (11.8mm) - switch to Elegoo Brown Layer 61 (12.2mm) - switch to Ziro Sparkly Green Layer 65 (13mm) - switch to Elegoo Sparkle Turquoise Layer 67 (13.4mm) - switch to Sunlu Mint Green Layer 69 (13.8mm) - switch to Sunlu Ice Blue