Inspired by Pop Funko Holder Honeycomb wall - normal rotation and Honeycomb storage wall. I really liked the idea of the little cutout, but found that I was a bit too rough and snapped the mounts fairly easily.

I completely redesigned this in FreeCAD to use the insert method of the standard Honeycomb Storage Wall for more rigidity and I've also widened the cutout to allow for the bobble-head style of Funko Pops to fit nicely. This also allows the model to be printed without supports. It does use more filament than the original model and is still weaker where the "nub" and "base" meet, but definitely stronger than before.

Make sure to print this with the large flat side on the bed.

Print Settings:

• Bambu A1 Mini
• OrcaSlicer
• 0.4mm Nozzle
• 0.20mm Layer Height
• 2 Wall Loops
• 15% Gyroid infill