Irreverent art depicting the Drifter and her protection - gothic steampunk style - hueforge art
Another bonus - reds are predominant in these last two.
For this model:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 133.33x200mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm
Filaments Used: PLA BambuLab Matte Scarlet Red Transmission Distance: 2 PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments
Swap Instructions: Start with Scarlet Red At layer #6 (0.56mm) swap to Black At layer #11 (0.96mm) swap to Blue Gray
Border Only Colors from here until the end. At layer #21 (1.76mm) swap to Jade White for the rest.






















