ALL Flexi Factory designs are protected by Copyright Law. When you purchase, you do NOT have the right to sell any digital file or printed model of my designs without my explicit written consent.

To legally sell PRINTED models, monthly ACTIVE membership is required through one of two available platforms below:

https://linktr.ee/flexifactory

Please help support the creative work of each 3D artist and NEVER share or sell a digital file.

3D model description

This Flexi Skeleton Velociraptor is an articulated "mostly" print-in-place model that needs NO supports. I say "mostly" because the head prints separately, and then you just snap it on.

Included are 10 files: *Skeleton Raptor_Body *Skeleton Raptor_Body_Straight (For printing smaller) *Skeleton Raptor_Head_With Eyes *Skeleton Raptor_Head_No Eyes *Skeleton Raptor_Head_Bottom *Skeleton Raptor_Bone A *Skeleton Raptor_Bone B *Skeleton Raptor_Stand *Skeleton Raptor.3mf (colored Bambu/Prusa file) *Skeleton Raptor_Stand.3mf (colored Bambu/Prusa file)

Also Optimized for AMS, meaning if you are using a Bambu or Prusa with multiple colors, you should easily be able to use the fill tool for coloring. I have added a 3mf as well for convenience!

Like with all my Flexi's, I went through many iterations to make sure it was strong, and easy to print without supports.

Please feel free to share images of your prints on this page, I would love to see 'em.

Thank you.

P.S. If you like this design, Check out my other models.

https://thangs.com/designer/flexifactory

Affiliate link to my supplies used in the photos above can be found here: https://www.amazon.com/shop/flexifactory

*As an Amazon Associate I earn from qualifying purchases.

3D printing settings Easy Print

-No Supports (adding supports will hinder functionality) -Mostly Print-in-place (head prints separately and pops in) -15% infill gyroid -I always like to use 3 walls

• .16 layer height or better suggested -Make sure you have good adhesion. I always use a glue stick. -Gradient PLA works great

To put the head on, set the "Head Top" onto the "Head Bottom", and press down. You will hear it snap on. Then Press the entire head onto the ball joint on the neck. Once in place, it's best not to try and remove it.

Go BIG or go home! the bigger the better for this model, but If you are printing small, I suggest going with the straight version or you might get a little lockup in the tail. I don't suggest going under 60%.