Last bonus for this evening. Dragon and the warrior face each other. Two STLs - main model with border and a second without. Drop the white for the non-border one and it prints with 4 colors.

For this model:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 120x200mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 7 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 5 unique filaments

Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #12 (1.04mm) swap to Orange At layer #16 (1.36mm) swap to Yellow

Border Only Colors from here until the end. At layer #26 (2.16mm) swap to Jade White for the rest.