This dragon is very easy to print. Being a "massive" model, it can be scaled down and printed on mini printers. Long and short versions are available, with rings on the face and not, and a preset scaling for minis. I printed with bambulab at a high quality setting and a 0.20 layer; the mini version, however, is printed at 0.16. The long version was printed in about 13:30 hours, the short in about 10:30 hours, and the mini in less than 10 hours. I use the brim for safety, but in the large version it may not be necessary.

Good calibration and retraction is necessary for a great result.

AMS/MMU READY: you can use “SMART FILL ANGLE”, easy! Watch the video tutorial in folder!

NOZZLE: 0,4 mm. LAYER: 0.16 OUTER WALLS: 3 INFILL: 10% SUPPORTS: NO Z-HOP: 0,8

For personal use only All my files are protected by Copyright, should NEVER be shared or resold.

To legally sell physical print of my design and if you want to get the latest Models and exclusive designs for your support visit my Patreon.