New type of model I am sharing with everyone. This is of a clock face and has a celtic knotwork design and a dragon at the center.

It is made to just fit the 235mm square bed of the bambu P1S/P1P/X1C. There is no hole at the center. You will obviously have to create one in order to affix a clock mechanism but is not a major issue.

In order for it to not curl on printing I have had to turn off the auxiliary fan and have no part fan for the first 2 layers. The first layer is a bit thicker than typical, at 0.24mm. ALSO, the corner has been cut from the "zero" level material to not have issues with extrusion areas for bambu owners.

SLICE to see it as round when printed.

For this Model:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 235x235mm in size You may print at higher layer heights below the Min Depth of 0.4mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments

Swap Instructions: Start with Black At layer #8 (0.8mm) swap to Blue Gray At layer #14 (1.28mm) swap to Beige At layer #17 (1.52mm) swap to Jade White for the rest.