Bonus model - This is a set of models that were first shared on Makerworld. There has been a lot of great comments and prints from them there, but a few people have had issue with how thin the black back is.

This was a very early set of models I did, and both I and hueforge have improved since then. I went through and updated the models with some improvements and decided to bring them over here to share as well.

For these models:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 68.33x205mm in size You may print at higher layer heights below the Min Depth of 0.24mm The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Tough Gray Transmission Distance: 1.8 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments

Swap Instructions: Start with Black At layer #5 (0.48mm) swap to Gray At layer #10 (0.88mm) swap to Silver At layer #14 (1.2mm) swap to Jade White for the rest.