Amazing Alien bust with hands that can be used as a magnet.

Since the eyes print separately, you can print this in colors with any 3d printer. All the parts fit together nicely, and you will just need to glue the to fix them in place.

Files included:

-Bust with hands attached -Bust and hands as separated files -Eyes -Pre-configured 3MF Factory Files for Bambu Slicer with a pause added at the right height for 5x2mm and 10x3mm magnets. -Pre-configured 3MF Factory Files for the eyes. -Clean versions of both Aliens so you can add your own holes to use with magnets.

You can add your own holes for the magnets on most slicers by adding a shape as a negative part (Always remember to leave an allowance of at least 0.2mm) placing it where desired and then add a stop at the right height so you can add the magnets.

"All of my models are for personal use only, unless you are an active subscriber with a commercial license."

3D PRINTING SETTINGS:

-No supports needed! -2 Walls and 5-8% rectilinear infill and 0.12mm layer height or lower. -Slow down and use a brim when printing the eyes.