1/8" PLA Truss Tower
18 downloads · 2 years ago · Felt like making the balsa wood school tower project a tad stronger...
**Model Specs:**
Length: 6"
Felt like making the balsa wood school tower project a tad stronger...
Model Specs: Length: 6" (152.4mm) Width: 6" (152.4mm) Height: 8" (203.2mm) Note: Wide Side Down!
Print Details: Material: Overture's Green PLA Nozzle: 210°C Bed: 65°C Walls/Top/Bottom: 3 Layers Thick Infil: 33% Cubic Sub Support: None BP Adhesion: Brim (20 Lines // Distance 0.02mm) GCode: Attached Below
Workout Coat Rack Holder v1.0
Workout Clamp Rack Holder v1.0
Dry Erase Kit Rack Holder v1.0
2-Inch Squat/Bench Rack End Caps
Custom Electric Boat - AP Physics 2 Project (Boat v4.1 - Cover v1.4)
Rook 1st Place Chess Trophy
1.5" Thick Home Gym Plate Stopper
"Bruh" Apple Watch Flat Charging Stand
The Rail v2
.gif&w=3840&q=75)
Ferdinand, the Highland Cow Ice Pint Holder
Slime Ball Fidget Toy by Ruven Bals Print in Place
Paper towel holder
Frodrick the Toilet Paper Dispenser
Sea Turtle - Cinder Hatchling
Magnetivy - English Ivy Fridge Magnet with Articulating Stems - Print in Place Hinges
Frames - Cargo Connect
Octopus - Cinder Hatchling
Dolphin - Cinder Hatchling
Infinite Notebook
