tracking pixel
Natalie C

Large String Eiffel Tower

by
3dprintbunny
Follow
Follow
Remix Model
J
jlconlin
Image 6 of 6
Large String Eiffel Tower - It was a little hard to glue together, but otherwise great. - 3d model
2D
3D
Makes
Large String Eiffel Tower 3d model
Large String Eiffel Tower 3d model
Large String Eiffel Tower 3d model
Large String Eiffel Tower - Printed with K1 Max, Creality Grey Hyper PLA - 3d model
Large String Eiffel Tower 3d model
Large String Eiffel Tower - It was a little hard to glue together, but otherwise great. - 3d model
This model is restricted by licensing terms. 
113 Likes75 DownloadsDecember 9, 2023
This model is restricted by licensing terms. 


A large string Eiffel Tower that stands at approximately 70cm tall and is printed in parts.

I have attached the stls and the Bambu Lab 3mfs and have added some instructions below. The pieces need to be glued together.

If you would like to print it and have any concerns or issues just drop me a message on social media. :)

All pieces need to be printed at 0.3mm layer height (if you are using Bambu Studio you need to set your wall generator to Arachne). For Level 5 and Top you need to use supports touching buildplate.

You need to print the following

4 x Base 4 x Level 2 4 x Level 3 1 x Level 4 4 x Level 5 1 x Top

Optional: I set my top layer to Hilbert Curve to give extra texture.


113 Likes75 DownloadsDecember 9, 2023




This model is restricted by licensing terms. 
113 Likes75 DownloadsDecember 9, 2023
This model is restricted by licensing terms.