Foldable laptop stand - Honeycomb 3d model

Foldable laptop stand - Honeycomb

429 downloads · 2 years ago · This is a remix of this design: https://www.thingiverse.com/thing:2345997 I added a honeycomb patter

This model is restricted by licensing terms.

View license.

Description

This is a remix of this design: https://www.thingiverse.com/thing:2345997 I added a honeycomb pattern to it so that it allows your laptop to breath better without sacrificing much strength. I also just like the look of it. Just like the original design, the two parts fit together to nicely fit in your backpack. A word of warning though, my 3D printers are very well tuned in and I still had to use force to pull apart the middle hinge. I recommend using a wedge to force the two parts apart. If you use a wedge, then it shouldn't even be necessary for your printer to be 100% tuned. I made the longer version for my Asus Vivobook 14. Check out my LinkTree here: https://linktr.ee/westinspace

Community Makes (2)

I had some issues with warping on 1 piece and there was some difficulties with the beginning on one end of the other one but they work so it's good.

I would suggest an improvement which is to increse the depth of the indent for the hinge in the bottom piece so that it can also be used for stabilizing the stand. Might as well, since there is an indent anyway. Just make sure there is still space for the hinge.
There is also a weird rectangle indent on one side of the little piece tht swings into place which I don't understand why is there, I'd remove that in a future update and just keep it flat.
I also like the bulb that snaps into place when you put the 2 pieces together for transporting, that's smart.

So overall I like this model.

Great design. Holds my laptop nicely. Thanks for posing it. My Anycubic Kobra 3 Combo was able to finish them in under 4 hours each. They came out looking great, and they are pretty sturdy.

Randy

Community Makes (2)

Discussions

pipesman71 year ago

Great design. Holds my laptop nicely. Thanks for posing it. My Anycubic Kobra 3 Combo was able to finish them in under 4 hours each. They came out looking great, and they are pretty sturdy. Randy

PrinterAnycubic Kobra

Print bed sizeX: 220 mm; Y: 220 mm; Z: 260 mm

MaterialPLA

Layer height0.2 mm

Infill density30 %

Huldar9 months ago

I had some issues with warping on 1 piece and there was some difficulties with the beginning on one end of the other one but they work so it's good. I would suggest an improvement which is to increse the depth of the indent for the hinge in the bottom piece so that it can also be used for stabilizing the stand. Might as well, since there is an indent anyway. Just make sure there is still space for the hinge. There is also a weird rectangle indent on one side of the little piece tht swings into place which I don't understand why is there, I'd remove that in a future update and just keep it flat. I also like the bulb that snaps into place when you put the 2 pieces together for transporting, that's smart. So overall I like this model.