July Model-Public
Public models will be released to Cults3d, MyMiniFactory, and Thangs after the one week early access period.
Hiya guys!
Lupa and her lil teddy bear pets are finally here! This one was quite the project. I am soooo happy with how they all turned out. 💜
I've been on a kick lately with printing stuff big... so of course I had to print Lupa big as well! Printed them all at 285% on the h2d. I ended up making some hoop earrings to print since my jump rings don't go that big 😆 They turned out rather well and were able to bend enough to get in her ears! I made a lil skull bead for them as well. I included the files for those that want to print her larger, can use normal jump rings for the 100% size.
This design is a bit harder to get to balance, her head is suuuper top heavy, especially the large one, but that is half the fun! ^_^
Info :
She prints in a few pieces that will need to be glued together.
The peg (print 2 of them) helps keep the pieces in place while the glue dries.
Has a solid back version that can be personalized by adding a negative volume/part in the slicer for different magnet or jump ring sizes.
Painted .3MF files are included, but you can change up the paint however you'd like!
Recommended that it is printed at 100% or larger.
General Settings :
- Print-in-place. No supports needed!
- 3+ perimeters (the more the stronger it will be).
- Inner before outer wall.
- Slow down outer wall speed.
- 0.2 maximum layer height. 0.1 for best detail.
- 15%+ infill.
- Enable bridge settings.
- Make sure to have good bed adhesion or use a brim!Made for FDM printing.
Filaments used :
🐈 Just a quick heads-up! Some of the links I share here are affiliate links. If you happen to make a purchase through one of them, I may earn a small commission at no extra cost to you. Thank you so much for supporting my dream and helping me create my magical little world of of creatures! 💖
HP3DF - Glitter White (used on the skull earrings)
🐺 Happy Printing!! 🐺
Rebecca 💜