Calipers are all just a little different which is why I created a universal caliper holder that registers off of the only consistent feature...the beam and the inside of the fixed jaw.
Hangs my calipers nicely. Coin cell battery has already fallen out. Maybe a little lip at the bottom of the slot to help retain a battery? (I assume that's what the slot on the side is for). Nice workable design, thanks!
Discussions — Caliper Holder (MP Bolt-Locked)
The bolt used in one of the images is this one https://thangs.com/designer/Multiboard/3d-model/Small%2520Thread%2520-%2520Multipoint-1123334
Thanks this was a little bit of a struggle to find for someone new to the system.
Thank you so much for the help first day with mulitboard system wasnt able to find the bolt then i read your comment
Thanks, I wish I had checked this before I printed out two others, but its the first week of multiboard, so thaks for the help.
why do the downloads not work?
Not working for me either.
I have the cheap calipers in the photo, but it does not hold them straight. Right side needs to move up.
Calipers are all just a little different which is why I created a universal caliper holder that registers off of the only consistent feature...the beam and the inside of the fixed jaw.
I was able to print this only by placing it on the table, with supports (
Bambu Lab A1
Good to see a multiboard accessory in the maker showcase
is it matter if we flip the caliper holder on the flat side? mean if a rotate 90 degre to the left from the stl file?
Hangs my calipers nicely. Coin cell battery has already fallen out. Maybe a little lip at the bottom of the slot to help retain a battery? (I assume that's what the slot on the side is for). Nice workable design, thanks!
Did I do something wrong? The bolt isn't flush with the caliper holder.
try the correct bolts - the ones linked above are not flush. https://thangs.com/designer/Multiboard/3d-model/Small%2520Thread%2520-%2520Multipoint-1123334
Can we get this for a 2032 coin cell? :-)