Update: A lot of people asked if this can fit cans, turns out it perfectly fits a 6 pack! I added a taller handle that can be used if you'll be using it for that. What a happy little accident!

I needed a caddy to carry some things around my studio so I made this!

It prints in three parts - the caddy, handle, and a wedge to lock the handle in from the bottom. To assemble, lightly flex the ends of the handle and insert it in from the top until the tabs snap into place. You can stop there, but if you want to be sure the handle never comes out, you can put a couple drops of CA glue in the bottom and insert the wedge piece.

Supports None needed!

Scaling Can be scaled up or down.

Orientation The caddy should have its bottom on the build plate. The handle and wedge should lay flat.

Print Settings .2mm layer height 15% grid infill 2 walls

Filament & Hardware Filament: Hatchbox Black Magic II PLA

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://hendricks.design/links/