I've made a lot of these types of planters, but I think this one hides the drip tray the best out of all of them! The lattice pattern and the angle change at the drip tray makes it basically disappear.

Forewarning: The 4.5" wall mounted one is quite a bit heavier than my other 4.5" planters, so use caution when hanging that size on the wall. I'd probably recommend using screws if you intend on printing that one.

Supports None needed!

Scaling I wouldn't recommend scaling this one since it perfectly fits the command strips and the screw holes are designed specifically for #10-12 x 1-1/4 in anchors and screws.

Orientation The planter and tray should have their bottoms on the build plate. All mounts should have the sliding dovetail facing up.

Print Settings .2mm layer height 15% grid infill (gyroid for the mounts) 2 walls

Filament & Hardware Filament:

• Bambu Lab Matte Charcoal PLA

Hardware:

• Command Medium Picture Hanging Strips
• #10-12 x 1-1/4 in anchors and screws

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods