Subscriber Exclusive! Bags... but make them cathedral windows!!! 🎉🎉

These print in parts, each side uses clips to hold them in place and can be swapped for different styles/colours! I recommend printing the clips in PLA or stronger so they are not flexible. The rest of the bag can be printed in PLA or TPU (or any others you want really).

The windows of course are semi transparent and will show lights through, so if your phone lights up so will your bag! Going to a rave? Add some fairy lights inside! 🌟

Can be printed single or multicolour!

PLA Settings - 0.2mm, 15%, 3walls TPU Settings - 0.2mm, 15%, 2walls

Edit to add info i forgot about earlier 😳

Middle section needs 4 magnets for the closure (rectangular 3x5x10mm) Hinge on the middle section uses a piece of filament, again id go PLA or stronger! Chains at some areas are very close and may need a craft knife to separate. You can remove links in the slicer to make it shorter aswell, or even use a different type of bag strap 😊