Introducing the Deathstar twist fidget, remixed from the original model by tato_713 found here https://www.printables.com/model/57266-death-star-scaled-one-in-two-million

A huge thank you to Tato_713 for allowing me the use of his fantastic fan created model

This is the twist fidget variant created by popular request, fully print in place with no brim, infill or support needed - 100% print in place

Includes multiple optimised print profiles for various slicers

Print settings as follows -

I recommend Arachne walls in your slicer (this helps reduce wall sticking, if you think your filament is well calibrated then this can be left to default wall generator

0% infill required

No supports enabled (no required so ignore any support warnings)

No brim

I recommend printing at the supplied scale