Knot a Vase
213 downloads · 5 years ago · Despite what you might think, this is “Knot a Vase.”
The lattice structures are between 1.8mm – 2.
This model is restricted by licensing terms.
View license.
Despite what you might think, this is “Knot a Vase.”
The lattice structures are between 1.8mm – 2.0mm, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
Knot a Vase
213 downloads · 5 years ago in
This model is restricted by licensing terms.
View license.
Large Mizu Gumi Picture Stands
Small Mizu Gumi Picture Stands
Bundle
Industrial Construction Set - FDM
Bundle
Bouali Strange Attractor Sculpture
Bundle
Aizawa Strange Attractor Sculpture
Bundle
Bio Blob
Bundle
Flame Lamp
Bundle
Crystal Lamp
Fidget Ouchies
Bundle
Tooth Fairy House
Bundle
Crystal Citadels
Bundle
Shack Pack - Sober
Bundle
Shack Pack - Tipsy
Bundle
Shack Pack - Plastered
Hole Through a Hole in a Hole
Holder for Reusable Straw
Bundle
Stellar Blooms
Bump Boxes
Bundle
Cut Crystal Eggs - Set 2
Bundle
