I have a Bambu labs P1S I slice the file and it says that I have floating areas and need supports. The instructions say no supports? Are you sure that I don't need supports?
Ignore the warning, print ahead, no supports. Cinderwing has yet to fail me!
However!!!!
I did find slowing my printing speeds down quite a bit for the outside layer and the top surfaces helped quite a bit. It’s under the speed setting on Bambu slicer.
I will run them on a standard textured a1mini plate with no glue (after a plate wash or a wipe down with alcohol), but only with the speeds turned down, and only when I’m within 60-150% of the original file size.
Discussions — Baby Steampunk Dragon
They look amazing please can I ask what you used?
i feel like i've been waiting so long for this! i'm so excited!!
Thanks for this!! Steampunk is my favorite dragon.
Eek it is on the printer now.... can not wait to see this !!
Etsy just banned commericial licensed 3d prints. Any ideas on how we're going to profit off from these print files?
I'd highly suggest you read my latest announcement. Etsy has done no such thing :)
I have a Bambu labs P1S I slice the file and it says that I have floating areas and need supports. The instructions say no supports? Are you sure that I don't need supports?
Yep! No supports. You'll learn the slicers are whiny babies hahaha
Im glad i seen this, i was gonna reach out and ask the same thing. Lol. Now i can print in confidence!!
lol thanks for responding. I just hit print and let it go last night.
Happens to me too. Yes, no supports. :)
Just have faith, and be careful trying to go too small!
I saw the exact same message on the slicer on my A1minis. I see it off and on, they all print fine from Cinderwing!
I cannot WAIT to get this one printed too!
Ignore the warning, print ahead, no supports. Cinderwing has yet to fail me!
However!!!!
I did find slowing my printing speeds down quite a bit for the outside layer and the top surfaces helped quite a bit. It’s under the speed setting on Bambu slicer.
I will run them on a standard textured a1mini plate with no glue (after a plate wash or a wipe down with alcohol), but only with the speeds turned down, and only when I’m within 60-150% of the original file size.
Anything else, glue stick!
I'm still learning to adjust the slicer settings. Where can I find how to adjust the outside layers and the top surface? Thanks for the suggestions.