Multiboard Alignment 12.5 Pillar
4 downloads · 5 months ago · This is for aligning multiple multiboard plates together. There is a hole for drilling a pilot hole
This is for aligning multiple multiboard plates together. There is a hole for drilling a pilot hole for pillar mounting. Large holes allow a large bolt to go through and secure multiple plates together.
The small holes will slide in and align the plates to each other.
This allows for a 12.5mm pillar height
Multiboard Alignment 12.5 Pillar
4 downloads · 5 months ago in and
Multiboard Alignment 6.25 Pillar
Multiboard Pillar Wrench.stl
Multiboard Align Screwdrivers.stl
12.5 mm - Mounting Pillar
Multiboard Tile Holder Tool
12.5 Offset - Small Hole Center Marking Tool
%2520-%2520VHB%2520Tape%2520Mount.png&w=3840&q=75)
12.5 mm - Dual Snap (DS Part A) - VHB Tape Mount
%2520-%2520VHB%2520Tape%2520Mount.png&w=3840&q=75)
12.5 mm - Quad Snap (DS Part A) - VHB Tape Mount
%2520-%2520VHB%2520Tape%2520Mount.png&w=3840&q=75)
12.5 mm - Single Snap (DS Part A) - VHB Tape Mount
Multiboard Keyhole Hangers Pegs
12.5 mm - Quad Bolt-Lock - VHB Tape Mount
Remix - 6.25 mm - Mounting Pillar - #8 Screw
12.5 mm Quad Bolt-Lock - ScrewOn Mount
12.5 mm - Dual Bolt-Lock - VHB Tape Mount
12.5 mm - Single Bolt-Lock - VHB Tape Mount
12.5 mm Single Bolt-Lock - ScrewOn Mount
12.5 mm - Quad Offset Snaps (DS Part A) Community Upload
Prototype: 3D Printed HOT SWAP Mechanical keyboard.
%2520-%2520x4%2520Stack.png&w=3840&q=75)
12.5 mm - Offset Snap (DS Part A) - x4 Stack
