@ anirealmsevil - I hope it works out! I've only seen one other resin print of this design, so I'm sure that brings some extra challenges into the mix!
I printed this out on my longer3d 10 resin printer, well most of it I need to get the case printed still. It was my FIRST ever print and it went over all pretty good. I ran into the toggle being printed misformed, but that's okay I can reprint that on its own later. I think it was sliced at an angle (still learning this stuff) and it had no supports so that's an oopsie. Might still work though. I gotta get the case printed and cured. I will comment again once I test it. Awesome print 3dPrinty
Ah great, thank you. I have been looking for an application to use some POM filament and I will see how the spring works rubbing against the Pivot triangle in PET. I'll post any discoveries, thanks!
*Update. Oof. Printing POM is a challenge. Might want to try printing it on 300 grit sandpaper or something.
PET has good lubricity so I'll make the pivots and spring out of it.
Discussions — Super Toggly Fidget Button
it came out pretty nice but i wish the springs were harder and clickier, because mine hardly has any resistance
Printed this. Works great. Thanks for the cool toy.
excellent design! 👏😎
Thanks! Your prints looked great!
im here
Welcome!
@ anirealmsevil - I hope it works out! I've only seen one other resin print of this design, so I'm sure that brings some extra challenges into the mix!
I printed this out on my longer3d 10 resin printer, well most of it I need to get the case printed still. It was my FIRST ever print and it went over all pretty good. I ran into the toggle being printed misformed, but that's okay I can reprint that on its own later. I think it was sliced at an angle (still learning this stuff) and it had no supports so that's an oopsie. Might still work though. I gotta get the case printed and cured. I will comment again once I test it. Awesome print 3dPrinty
Nice alternate spring! And thanks for sharing that and the results from your alternate materials experiments.
Yeah I've confirmed that the toggle - "ironed" PLA and the spring - POM for really slippery action.
27JUL21 Update -- got the spring to print in POM. Smoother, but squeaks rubbing against the PET. I'll see about the PLA
https://thangs.com/Morb-Orgus/springSTL-22555
I modified the spring a bit for additional fidgety feedback. I've always liked "over-center" type spring mechanisms and FFF prints them well.
@Morb Orgus - Good luck! I'd love to hear how the it works out, all my current copies are in PLA.
Ah great, thank you. I have been looking for an application to use some POM filament and I will see how the spring works rubbing against the Pivot triangle in PET. I'll post any discoveries, thanks!
*Update. Oof. Printing POM is a challenge. Might want to try printing it on 300 grit sandpaper or something.
PET has good lubricity so I'll make the pivots and spring out of it.
@Morb Orgus - There's not currently a diagram, but the complete assembly process is shown in this video: https://youtu.be/zfiyeE8l3-0
Do you have a diagram of how this will be built? I want to print this FFF.