Is anything else to change at the printer? Like software? Or is it plug and play? This will be the first mod I will do on my printer when it arrives :-)
The BTT Eddy cannot be utilized on the default Klipper that comes with the printer. Come to the discord, some dudes have gotten Klipper to the Mainline version, but know you need skills, and a 4 dollar st-link V2 to flash the klipper install on the toolhead.
For anyone reading this as of 10/16/24: I do not recommend this mount for the eddy, not without making modifications anyway. The Eddy will sit about 5-7mm higher than what the BTT instructions indicate to do.
OP, please review the BTT Eddy documents and readjust the sensor for the correct height. Per BTT docs:
4.1. Installation Height
Install Eddy 2 to 3 mm above the nozzle to ensure optimal performance. If you
encounter any errors during the calibration process, these may be related to
Eddy'
Switched the SV08 to mainline klipper and installed the eddy USB. Followed the BTT instructions and all was good until I changed the printer.cfg. Then I get various [probe] section errors. Could someone share a working printer.cfg?
Hey, thanks for this wonderful fitting mount :)
can you maybe share your cfg file ? :) i have issues to get the probe with the automatic z_offset (pressure probe) working .. :(
Yeeeah...I had to make my own actually ^^; used onshape, so easy peasy to share the CAD but I'll also be sure to edit the model page with a STEP of what I put together for future reference! Hope it helps you!
Discussions — BTT Eddy SV08 Mount
Where exactly does this get wired to on the toolhead
Do the probe offsets need to be changed for the eddy ?
Is anything else to change at the printer? Like software? Or is it plug and play? This will be the first mod I will do on my printer when it arrives :-)
The BTT Eddy cannot be utilized on the default Klipper that comes with the printer. Come to the discord, some dudes have gotten Klipper to the Mainline version, but know you need skills, and a 4 dollar st-link V2 to flash the klipper install on the toolhead.
Whats the link to discord if you don’t mind me asking?
https://discord.gg/KCtQkbAE
Discord tells me the link is invalid or expired.
Thanks for this! Such an elegant design you came up with. I will test it out when everything arrives.
For anyone reading this as of 10/16/24: I do not recommend this mount for the eddy, not without making modifications anyway. The Eddy will sit about 5-7mm higher than what the BTT instructions indicate to do.
OP, please review the BTT Eddy documents and readjust the sensor for the correct height. Per BTT docs:
4.1. Installation Height Install Eddy 2 to 3 mm above the nozzle to ensure optimal performance. If you encounter any errors during the calibration process, these may be related to Eddy'
What is the offset?
What is the offset?
Switched the SV08 to mainline klipper and installed the eddy USB. Followed the BTT instructions and all was good until I changed the printer.cfg. Then I get various [probe] section errors. Could someone share a working printer.cfg?
you still have probe listed in your save config area of the printer cfg. Remove it.
Do you have instructions for setting this up and installation?
Hey, thanks for this wonderful fitting mount :) can you maybe share your cfg file ? :) i have issues to get the probe with the automatic z_offset (pressure probe) working .. :(
May I ask where did you get the CAD file for the Eddy board? The one in the Eddy's Github is not as good.
Yeeeah...I had to make my own actually ^^; used onshape, so easy peasy to share the CAD but I'll also be sure to edit the model page with a STEP of what I put together for future reference! Hope it helps you!