Shaped through a flowing swirl of continuous lines, this pendant light captures a sense of gentle movement frozen in time, casting a soft glow into any space. Try out different filaments such as transparent PETG or Matte PLA to get different textures and light diffusion! A pendant light kit is required for this print, check out the link below for the pendant light kit I use. This was printed on a Bambulab P1P.

Instructions

• 3MF file and individual STLs are included
• Use a lower layer height such as .12mm for a higher quality finish and print (Optional)

Lamp Shade

• No supports required
• Enable "Spiral Vase Mode"
• Uncheck "Slow Down for Overhangs" in the "Speed" section (Without this step it may cause unevenness in areas of the print as it attempts to slow down at the overhangs)
• Set "Outer Wall" line width as 0.6-0.8mm (The original 0.42mm is fine, but a thicker wall creates a sturdier shade)
• Increase "Bottom Shell Layers" Under "Strength" if you want a sturdier base surface for the pendant light kit to hold on to (Optional)
• Do dry your filament before printing if possible to reduce uneven surfaces, stringing and blobbing (Optional)

Filament

• ESUN White PLA+ (Lamp Shade)

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/xunodesign

Need help? Drop me a message here or DM me on Instagram! Check out my reel on Instagram or Tiktok to see how I made this!