Use these simple blocks to mount your workshop pegboard.

1. Hold your pegboard on the wall marking hole locations where you'd like blocks to be placed (Should follow studs unless your using drywall anchors).
2. Then line up the center hole with your marks and secure the block in place with a screw through the top hole.
3. Then match your pegboard up to the blocks you have placed and start sinking screws with the washers through your pegboard and blocks center holes.

Printing instructions

• Use high infill 80-100% as you want these to be very sturdy so your tools dont fall off the wall.
• no supports needed aslong as correct orientations are used during printing.

These are free to use for anyone! You can also check out my various pegboard organization models for free or some even for purchase!