Rattle snake, with print in place rattle tail. includes a glass eye version and printable eye version.

for the rattle tail, it is print in place, simply press the bearings into the cavity once printed. please bear in mind that if you scale down the built in supports for the bearings may not print as they are just a single layer. the snake is 64 segments long at 100% it fits nicely on a 256x256 build plate. for a full H2D build plate its 120% for the glass eyes please make sure its printed at 100%. and use 8mm glass eyes. other than that its 0.2 layer height, 5-15% infill the green snake is a green gradient by ziro and the multicolour layered version is all bambu matte