Zombie Dragon Bust

a 4 colour print, however you can colour as little or as much as you like using the paint fill tool. The 3MF is pre coloured.

Prints with minimal supports. Ive done my best to minimise overhangs in the model. while is doe need some supports its not too bad. set the support threshold angle to 26, and top z to 0.275. this is pre set in the 3mf.

I originally designed it to print as one, but it was a struggle to get it to print without failure, so went back to the drawing board and split to some parts. you have 2 sides, and 2 horns. its fairly obvious what side is what. and they connect using a small square connector. you will need to glue.

The bust then slides on the back. you can glue if you like but it's a nice fit dependant on the filament choice. I used a matte dark brown. and being a matte has a bit more grip.

The back board. Ive included in the back board 2 hidden cylinders in the built in connectors. These are both set to 30% infill. This is to make sure the connectors are stronger. The infill is pre set in the 3MF. To access the cylinders, click the drop down arrow on the back in objects in the 3 mf. If using the STL you'll need to right click the object and split to parts. There are also 2 screw mounts in the back

Filaments, Bambu Matte bone white, dark brown, basic marroon red, white, eryone dual white and blue matte.

0.2 layer, 5-10% infill, 30% for the hidden cylinders