RAMA | Spice Rack for kitchen rail

This is the spice rack, part of the RAMA collection of kitchen rail accessories. It can fit spice jars with a diameter up to Ø70mm. The total length of the rack is 245mm, width is 80mm.

The collection includes:

• a FREE set of wall brackets for Ø18mm or 3/4inch wooden rails, plus hanging planters and hooks.

And the following accessories:

• a magnetic knife rack
• a cookbook or ipad shelf
• a dishsoap and spong holder
• a drip tray to dry your cutlery
• a spice rack
• a towel holder

3D PRINT SETTINGS: All STL files are all already oriented properly. No need for supports, or brim.

The hangers print on their side and don't need support, even for the overhanging part.

The bottom plate of the rack will appear "full", this is not a mistake. You can print it as is. Or turn it into a "see-through mesh" by selecting an infill pattern of your choice, and setting the top and bottom layers to 0. On the example on the pictures, I used a 20% honeycomb infill.

Layer height: 0.2mm/layer Wall line count: 3 Top layers: 0 (to cancel top face) Bottom layers: 0 (to cancel bottom face) Infill: 15 to 20% (honeycomb on the pictures) Build adhesion type: None Supports: None