Print any size, Spaceman from small to large, print this flexi spaceman any size. The Visor prints separately and dependant on size will clip in. if you go super large the tolerance increases meaning you may just need a little glue. On the opposite end printed at its smallest and ive tested to 30% the viper may be a little tight but does still clip in. If you are struggling just scrape round the edge with a knife a couple of times. flexible but free standing, similar to the robot a made recently. 0.2 Layer, 10-15% infill no supports As always the model is made from many bodies that are easily colourable, using the paint fill tool. filaments used are all bambu Basic.